Owens Corning
Architectural shingles
Metal roofing
Tile roofing
GAF
Flat & low-slopeFree roof inspection with deck photos before we talk money - GAF and Owens Corning certified installation
Owens Corning Specialty Roofing in Boulder City: What to Know First
We install and service Owens Corning specialty roofing in Boulder City as an independent Owens Corning service provider. Most flat and low-slope jobs here run one to three days, while a full Solar Ready or built-up system on a larger home can stretch a week depending on weather and deck repairs. We quote a fixed, line-item number up front, and we never change it mid-job without your written approval.

This page is for Boulder City homeowners who already have an Owens Corning system on the roof – maybe a TPO membrane on a patio cover, a Modified Bitumen flat section over an addition, or an older built-up roof – and need someone who knows how those products actually behave in our desert heat. If that’s you, call (844) 761-8186 and a live person will pick up.
How Owens Corning Products Fail – and How We Fix Them
Owens Corning makes good material. What fails is the detailing, the sun, and the fact that our climate swings about 40 degrees between a July afternoon and a summer night. Here’s what we actually see on Owens Corning specialty systems around Boulder City:
- TPO membrane seam separation (Owens Corning FlexTherm and similar single-ply lines). Heat-welded seams let go when the weld was run too cool or too fast at install. You’ll spot it as a faint gray line along a seam, then water tracking underneath. We cut back the failed seam, re-weld it hot and slow, and probe the whole field for soft spots before we call it done.
- Modified Bitumen alligatoring (Owens Corning DeckSeal and comparable cap sheets). The granulated surface on a mod-bit cap dries out and cracks in a checkerboard pattern after years of UV. Once it alligators, the asphalt underneath is exposed and the sheet is on borrowed time. We clean, prime, and either re-cap the field or patch the brittle sections, depending on how far it’s spread.
- Built-up roofing blistering (Owens Corning ply and cap sheet systems). Trapped moisture or air under a BUR layer blisters when the surface heats. A blister that pops is a leak waiting. We open it, dry the deck, and re-lay the plies rather than smearing mastic over the top – the smear looks fixed for one season and then fails.
- EPDM shrinkage at terminations (Owens Corning rubber membrane lines). Rubber pulls back from the edge over time, especially on a west-facing parapet. The pull creates a gap the wind grabs. We re-terminate with a proper bar and new fasteners instead of stapling the edge and hoping.
- Solar Ready underlayment wrinkles and ponding. Owens Corning Solar Ready systems are built to carry panels later, so the deck and underlayment have to be flat. We see ripple where the decking wasn’t re-nailed before the membrane went down, and ponding where the slope was shimmed wrong. We correct the slope and re-nail the deck before any new membrane goes back on.
Styles & brands we work with
- Architectural shingles
- Metal roofing
- Tile roofing
- GAF
- Owens Corning
- Flat & low-slope
Our Owens Corning Specialty Roofing Process
Every Owens Corning job starts with eyes on the roof, not a phone quote. Here’s how a job runs from your first call to the sweep-up:
- 1
Call and a real look. You call, a live person answers, and Bill or one of his crew comes out to walk the roof, photograph the deck, and note every seam, flashing, and drain.
- 2
Diagnosis before the pitch. We measure in squares, count them out loud, and show you the deck photos before we talk money. You’ll know the actual square count at bid time, same as any honest bidder.
- 3
Parts decision. For Owens Corning systems we use OEM membrane and flashing wherever the warranty depends on it. Where a quality aftermarket termination bar or fastener does the same job without voiding coverage, we’ll say so and price both.
- 4
The install or repair. Deck repairs, new underlayment, membrane laid and welded hot. Background-checked crew, uniformed, with Bill’s own sons on the roof. We pull the permit where one is required.
- 5
Water test and walkthrough. We flood-test or hose-test the field and every termination, then walk you around and show you what we did and where.
- 6
Cleanup and the 90-Day Done Right Promise. Magnets over the yard, debris hauled off, and the written guarantee in your hand. If something isn’t right, one call brings Bill back.
See the difference
Before
After
Before
After
Before
AfterWhat Owens Corning Specialty Roofing Costs in Boulder City
Prices below are real ranges for Owens Corning work around Boulder City. Your number depends on square footage, deck condition, and how many terminations and drains the job has.
| Job | Typical range |
|---|---|
| TPO seam re-weld or small membrane patch | $350 – $900 |
| Modified Bitumen re-cap (small flat section) | $1,200 – $2,800 |
| EPDM re-termination at parapet | $450 – $1,100 |
| Full TPO or mod-bit flat roof replacement (per square) | $550 – $1,100 per square |
| Built-up roof replacement with deck repairs | $9,000 – $22,000+ |
What moves the price: deck rot, added drains, height and access, and whether we’re matching an existing Owens Corning system or replacing a full field. Free estimates, no trip charge inside our county, and a free second opinion on any written estimate you already have. Call (844) 761-8186 to schedule yours.
Why Boulder City Homeowners Call Shepherd & Sons Roofing Boulder City for Owens Corning Work
We’ve had the same address since 1996 and the same name on the license the whole time. Storm chasers roll through after every hail event in Boulder City and quote one number on the phone, then another at the door. You won’t get that from us. A live person answers 24/7, including nights and weekends. We stand behind every job with the written 90-Day Done Right Promise. Our technicians have up to 30 years of experience, and they’ve set Owens Corning, GAF, and CertainTeed systems enough times to know how each one details. We also install GAF and CertainTeed when an Owens Corning match isn’t the right call for your roof. No guessing who’s accountable – Bill’s name is on the work and he answers his own phone.
Standing offers we always keep on the table: $40 off any repair over $200, a free second opinion on any written estimate, no trip charge inside our own county, and a 10% senior and veteran discount.
FAQs
Yes – as an independent service provider, we use OEM Owens Corning components on warranty-critical repairs, and our spec matches the manufacturer’s requirements. For non-critical parts like termination bars and fasteners, we’ll tell you when a quality aftermarket alternative is fine and when it isn’t. We don’t claim to be authorized by Owens Corning. Call (844) 761-8186 and we’ll walk your specific system through it.
Repair when the failure is isolated and the field is still sound – a single failed seam or one popped blister is a repair. Replace when the cap sheet has alligatored across most of the field or when we find deck rot under the membrane. We’ll show you the deck photos so you can see the difference yourself. Call (844) 761-8186 for a free estimate.
A live person answers 24/7, including after a storm, and we work storm damage calls in and around Boulder City as quickly as we can get to them. A full replacement is a planned job, not a same-day fix. For a small seam failure or patch, most jobs move fast once we’re on the roof. Call (844) 761-8186 and tell us what you’re seeing.
Yes – we pull the permit where one is required and the inspection is part of the job. Flat and low-slope reconfigure and new membrane installs usually need one; small patches often don’t. We’ll tell you up front which applies to yours. Call (844) 761-8186 for a straight answer.
Nothing. Estimates are free, there’s no trip charge inside our own county, and we’ll give you a free second opinion on any written estimate you already have. Call (844) 761-8186 to schedule.
We’re proud to do Owens Corning specialty roofing in Boulder City for the homeowners who want a roofer they’ll see again at the hardware store on a Saturday. Call (844) 761-8186 for a free estimate – a live person answers, we’ll come out, and you’ll see the deck photos before we talk money.
Written by the team at Shepherd & Sons Roofing Boulder City, serving Boulder City and nearby areas.